ASTM A370-19e1 pdf free download.Standard Test Methods and Definitions for Mechanical Testing of Steel Products.
1.1 These test methods cover procedures and definitions for the mechanical testing of steels, stainless steels, and related alloys. The various mechanical tests herein described are used to determine properties required in the product specifications. Variations in testing methods are to be avoided, and standard methods of testing are to be followed to obtain reproducible and comparable results. In those cases in which the testing requirements for certain products are unique or at variance with these general procedures, the product specification testing requirements shall control.
1 .4 The values stated in inch-pound units are to he regarded as the standard.
1.5 When this document is referenced in a metric product specification, the yield and tensile values may be determined in inch-pound (ksi) units then converted into SI (MPa) units. The elongation determined in inch-pound gauge lengths of 2 or 8 in. may he reported in SI unit gauge lengths of 50 or 200 mm, respectively, as applicable. Conversely, when this document is referenced in an inch-pound product specification, the yield and tensile values may be determined in SI units then converted into inch-pound units. The elongation determined in SI unit gauge lengths of 50 or 200 mm may he reported in inch-pound gauge lengths of 2 or 8 in.. respectively, as applicable.
1.5.1 The specimen used to determine the original units must conform to the applicable tolerances of the original unit system given in the dimension table not that of the converted tolerance dimensions.
Nom 1—This is (tue to the specimen SI dimensions and tolerances being hard conversions when this is not a dual standard. The user is directed to Test Methods A 1058 if the tests are required in SI units.
1.6 Attention is directed to ISO/IEC 17025 when there may he a need for information on criteria for evaluation of testing laboratories.
1 .7 This standard does not purport to address all of the safet concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1 .8 This international standard was developed in accordance With mternationallv recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recoininendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Commiitee.ASTM A370 pdf download.