ISO IEC 11801-1:2017 pdf download.Information technology - Generic cabling for customer premises
1 Scope
This part of ISO/IEC 11801 specifies requirements that are common to the other parts of the ISO/IEC 1 1801 series. Cabling specified by this document supports a wide range of services including voice, data, and video that may also incorporate the supply of power.
This document specifies:
a) the fundamental structure and configuration of generic cabling requirements within the types of premises defined by the other parts of the ISO/IEC 11801 series,
b) channel transmission and environmental performance requirements,
c) link performance requirements,
d) backbone cabling reference implementations in support of the parts of the ISO/IEC 11801 series,
e) component performance requirements, referring to available International Standards for components and test methods where appropriate,
f) test procedures to verify conformance to the cabling transmission performance requirements of the ISO/IEC 11801 series.
NOTE This document does not contain specific conformance requirements. The cabling design documents supported by ISO/IEC 11801-1 incorporate the requirements of this document as part of their individual conformance requirements.
In addition, this document provides information regarding the applications supported by the cabling channels.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
IEC 60352-2, Solderless connections - Part 2: Crimped connections - General requirements,test methods and practical guidance
IEC 60352-3, Solderless connections - Part 3: Solderless accessible insulation displacement connections - General requirements, test methods and practical guidance
IEC 60352-4，Solderless connections - Part 4: Solderless non-accessible insulation displacement connections - General requirements, test methods and practical guidance
IEC 60352-5，Solderless connections - Part 5: Press-in connections - General requirements,test methods and practical guidance
IEC 60352-6，Solderless connections - Part 6: Insulation piercing connections - General requirements, test methods and practical guidance
IEC 60352-7，Solderless connections - Part 7: Spring clamp connections - General requirements, test methods and practical guidance
IEC 60352-8, Solderless connections - Part 8: Compression mount connections - General requirements, test methods and practical guidance
IEC 60512-4-1, Connectors for electronic equipment - Tests and measurements - Part 4-1:Voltage stress tests - Test 4a: Voltage proof
IEC 60512-4-2，Connectors for electronic equipment - Tests and measurements - Part 4-2:Voltage stress tests - Test 4b: Partial discharge
IEC 60512-6-2，Connectors for electronic equipment - Tests and measurements - Part 6-2:Dynamic stress tests - Test 6b: Bump
IEC 60512-6-3, Connectors for electronic equipment - Tests and measurements - Part 6-3:Dynamic stress tests - Test 6c: Shock
IEC 60512-6-4，Connectors for electronic equipment - Tests and measurements - Part 6-4: Dynamic stress tests - Test 6d: Vibration (sinusoidal)
IEC 60512-11-4, Connectors for electronic equipment - Tests and measurements - Part 11-4:Climatic tests - Test 11d: Rapid change of temperature
IEC 60512-11-7, Connectors for electronic equipment - Tests and measurements - Part 11-7:Climatic tests - Test 11g: Flowing mixed gas corrosion test
IEC 60512-11-9, Connectors for electronic equipment - Tests and measurements一Part 11-9:Climatic tests - Test 11i: Dry heat.ISO IEC 11801-1 pdf download.