CSA 11.1:2017 pdf download.Portable type gas camp lights
1.8 CSA 11.1 contains SI (Metric) equivalents to the yard/pound quantities, the purpose being to allow the Standard to be used in SI (Metric) units. (EEE/ASTM SI 10, American National Standard for Metric Practice, or ISO 80000-1:2009, Quantities and units - Part 1: General is used as a guide in making metric conversion from yard/ pound quantities.) If a value for a measurement and a corresponding value in other units are stated, the first stated value is to be regarded as the requirement. The given corresponding value may be approximate. If a value for a measurement and a corresponding value in other units are both specified as a quoted marking requirement, the first stated unit, or both are to be provided.
4.1.5 The light shall be of such construction as to be secure against displacement, distortion, warping, or other damage, and shall be supported to maintain a fixed relationship between essential parts under normal and reasonable conditions of handling and usage so as to determine continued compliance with these provisions. Such parts not permanently secured shall be designed so that they cannot be readily incorrectly assembled and cannot be improperly located or misaligned in removing or replacing during use, cleaning, or other servicing.
4.1.6 If any indication is observed during the tests prescribed herein that the appliance will not continue to meet these provisions in normal usage, such supplementary tests shall be conducted that will provide safe and satisfactory service.
4.7.5 A regulator shall have a predictable outlet pressure. Three samples shall be tested. The regulators shall be set at their full open setting. Inlet pressures as stated in Clause 5.3.1-b shall be applied to all regulators. Pressures for propane/butane mixtures shall be determined by the certification agency. The outlet pressures measured at each regulator shall be within 20 percent of each other.
4.7.6 Regulators that comply with the Standard for Gas Appliances Pressure Regulators, ANSI Z21.18 CSA 6.3 at the above temperature ranges need not comply with Clauses 4.7.3 through 4.7.5.
4.8 Hose and hose fittings
Hose and hose fittings for use with a light shall be supplied by the manufacturer and shall comply with the Standard for Pigtails and Flexible Hose Connectors for LP-Gas, UL 569, or with the Standard for Elastomeric Hose and Hose Couplings for Conducting Propane and Natural Gas, CSA 8.1 or the Standard for Thermoplastic Hose and Hose Couplings for Conducting Propane and Natural Gas, CSA 8.3.CSA 11.1 pdf download.