IEEE Std C37.100.1:2018 pdf download.IEEE Standard for Common Requirements for High-Voltage Power Switchgear Rated Above 1000 V.
IEEE Std C37.100.1 applies to alternating current (ac) switchgear, designed for both indoor and outdoor installation and for operation at service frequencies up to and including 60 H. on systems having voltages above 1000 V.
This standard is applied in relevant equipment standards by a normative reference to this standard, IEEE Std C37.l00.1, 011 a section or clause-by-clause basis. Annex A of this standard provides recommendations for its application.
The inclusion of this standard as a normative reference shall not imply that all of the requirements contained herein apply as a default. In the absence of a normative reference, this standard shall be considered informative only. In case of a conflict in requirements, the requirements of the relevant equipment standard shall prevail.
NOTE 1— In general, this standard applies to all high-voltage power switchgcar designed to IEEE C37TM series. Exceptions include low-voltage standards (less than l(X)() V) and protective relay standards.’
NOTE 2—For the use of this standard, bhigh voltage” (see 1EV 6Ol0l27)2 is the rated voltage above 1 kV. However, the term ‘medium voltage” (see 1EV 601-01-28) is commonly used for distribution systems with voltages above I kV and generally applied up to and including 52 kV.
NOTE 3—There are many common requirements found in the IEEE C37 switchgear standards. These include service conditions, ratings. such as temperature rise limits, and test methods. This common requirements standard is provided to promote standardization of the requirements and to simplify the maintenance of these standards.
1.2 Purpose
This document does not include a purpose statement.
2. Normative references
The following referenced documents arc indispensable for the application of this document (i.e., they must be understood and used, so each referenced document is cited in text and its relationship to this document is explained). For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments or corrigenda) applies.
NOTE 1—References to IEC standards are either informative or offer an alternative to an IEEE standard. The user is cautioned that the IEEE standard and the IEC standard, while comparable, may not be equivalent. The use of an IEC standard should be based on agreement among the user, the manufacturer, and the certifying test laboratory. Use of an IEC standard for a design (type) test should be noted in the test report.
NOTE 2—International standards not referenced in this clause are to be considered informative and are listed in the bibliography in Annex K.
ANSI C63.2, American National Standard for Electromagnetic Noisc and Field Strength Instrumentation, 10 Hz to 40 GHz—Spccitications.
IEC 60060-1, High-voltage test techniques— Part 1: General definitions and test requirements.
IEC 60060-2, High-voltage test techniques—Part 2: Measuring systems.IEEE Std C37.100.1 pdf download.