ISO 582:1995 pdf download.Rolling bearings - Chamfer dimensions - Maximum values
1 Scope
ISO 582:1995 pdf download specifies the maximum chamfer dimensions of metric series rolling bearings, for which boundary dimensions, including chamfer minimum dimensions, are given in other International Standards. Requirements for the maximum dimensions of the corresponding shaft and housing fillet lddii die diso given.
It does not apply to chamfers, for which dimensions are not specified, or for which other dimensions are specified in other International Standards.
2 Normative references
The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, thc oditions indicated were valid, All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards.
ISO 15:1981, Rolling bearings — Radial bearings — Boundary dimensions — General plan.
ISO 104:1 94, Rolling bearings — Thrusr bearings — Boundary dimensions, general plan.
ISO 246:1995. Rolling bearings — Cylindrical roller bearings, separate thrust collars — Boundary dimensiGns.
ISO 355:1977, Rolling bearings — Metric tapered roller bearings — Boundary dimensions and series designa tions.
ISO 464:1995, Rolling bearings — Radial bearings with locating snap ring — Dimensions and tolerances,
ISO 12043:1995, Rolling bearings — Single-row cylindrical roller bearings — Chamfer dimensions for loose-rib and non-rib sides.
ISO 12044:1995, Rolling bearings — Single-row angular contact ball bearings — Chamfer dimensions for outer ring non-thrust side
3 Definitions
For the purposes of this International Standard, the
following def,nitions apply.
3.1 radial direction chamfer dimension (of a bearing ring or washer): The distance between the imaginary sharp ring or washer corner and the intersection of the chamfer surface and the ring or washer face.
3.2 axial direction chamfer dimension (of a bearing ring or washer): Ihe distance between the imaginary sharp ring or washer corner and the intersection of the chamfer surface and the bore or outside cylindrical surface of the ring or washer.
4 Symbols and dimensions
See figure 1 and tables 1 to 5.
The dimensions given in tables 1 to 5 corresponding to symbols shown in figure 1 aro nominal dimensions unless specified otherwise.ISO 582 pdf download.