ISO 603-5:1999 pdf download.Bonded abrasive products - Dimensions
1 Scope
This part of of ISO 603 specifies the nominal dimensions, in millimetres, of:
— Type 2: Cemented or clamped cylinder wheel
— Type 6: Straight cup wheel
— Type 31: Segments
— Type 35: Cemented or clamped disc wheel
— Type 36: Disc wheel with inserted nuts
— Type 37: Cylinder wheel with inserted nuts
These bonded abrasive products are intended to be used for surface grinding where the workpiece is secured to a
reciprocating table that moves in a straight line. The workpiece and the grinding wheel are mechanically guided.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this part of ISO 603. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this part of ISO 603 are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the lates edition of the normative document referred to applies. Members of ISO and lEG maintain registers of currently valid International Standards.
ISO 525:1999, Bonded abrasive products — General requirements.
ISO 6103:1999, Bonded abrasive products — Static balancing of grinding wheels — Testing.
ISO 13942:_1), Bonded abrasive products — Limit deviations and run-out tolerances.ISO 603-5 pdf download.