AWWA C500-09 pdf download.Metal-Seated Gate Valves for Water Supply Service
AWWA C500-09 describes iron-body, brass-mounted, nonrising-stem (NRS) gate valves, including tapping gate valves, 3-in. (75-mm) NPS through 48-in. (1,200-mm) NPS, and outside screw and yoke (OS&Y) rising-stem gate valves, 3-in. (75-mm) NPS through 24-in. (600-mm) NPS, with either double-disc gates having parallel or inclined seats, or solid-wedge gates. These valves are suitable for use in approximately level settings in water systems. T ese valves are intended for applications where fluid velocities do not exceed 16 ft/sec (4.9 m/sec) when the valve is in the fully open position.
1.1.1 Valve pressure ratings. Teminimum design working water pressure shall be 200 psig (1,380 kPa) for valves 12-in. (300-mm) NPS and smaller, and 150 psig (1,050 kPa) for valves with diameters of 14-in. (350-mm) NPS and larger.
1.1.2 Conditions and materials not described. T is standard is not intended to describe special conditions of gate-valve installation or operation such as built- in power drive, installation in unusually corrosive soil, conveyance of unusually corrosive water, excessive water hammer, or operation in a throttled position. Such conditions are beyond the intended scope of this standard and require special con-sideration in design and construction. Joint accessories for end connections, such as bolts, gaskets, glands, follower rings, and so forth, are not described in this standard.
Sec. 1.2 Purpose
Tepurpose of this standard is to provide purchasers, manufacturers, and suppliers with the minimum requirements for metal-seated gate valves for water supply service, including materials, design, testing, inspection, rejection, marking, and shipping.
Sec. 1.3 Application
This standard can be referenced in specifi cations for purchasing and receiv- ing metal-seated gate valves for water supply service. T e stipulations of this stan- dard apply when this document has been referenced and then only to metal-seated gate valves for water supply service.
4.1.3 Assembly drawings.
Temanufacturer shall submit to the purchaser one set of drawings showing the principal dimensions, construction details, and materials used for all parts of the valve. Work shall be done and valves shall be provided in accordance with these drawings after the drawings have been reviewed and accepted by the purchaser.AWWA C500-09 pdf download.